If the objective lens becomes dirty, it will interfere with optical fiber observation, causing errors and high connection loss. Cleaning to remove dirt is important for the correct recognition of optical fibers.
If the objective lens becomes dirty, it will interfere with optical fiber observation, causing errors and high connection loss. Cleaning to remove dirt is important for the correct recognition of optical fibers.
Electrodes
Objective lens
Dirt on lens
No dirt After cleaning
Timing or Frequency to clean objective lens
Recommended frequency to clean: One month “Depending on frequency of use”
Please clean objective lens, when…
R-Too or L-Too Dusty Fiber error
X or Y-Dark back Ground error
R-Too or L-Too Long Fiber error
ZL or ZR Motor Overrun error L/R-Bad Fiber Position error
Large Gap Offset or Large Cleave Angle error occurs or can not be inspected When the “ gap difference ” can not be set
Please clean objective lens, when…
R-Too or L-Too Dusty Fiber error
X or Y-Dark back Ground error
-Too or L-Too Long Fiber error
ZL or ZR Motor Overrun error L/R-Bad Fiber Position error
Large Gap Offset or Large Cleave Angle error occurs or can not be inspected When the “ gap difference ” can not be set
Necessary Item
Procedure
1. Open the wind protector by the hand. Turn the fixing screw of the fusing electrode rod by hand and remove it from the fusion splicer.
Do not touch the removed electrode rod. In particular, be careful not to bend the tip of the electrode rod as it is an important part of arc fusing.
1. Open the wind protector by the hand. Turn the fixing screw of the fusing electrode rod by hand and remove it from the fusion splicer.
*Do not touch the removed electrode rod. In particular, be careful not to bend the tip of the electrode rod as it is an important part of fusing.
2. Wipe off any dirt on the two objective lenses with a cotton swab soaked in alcohol.Use new cotton swabs for cleaning the lens at each location and do not reuse them.At this time, wipe the optical fiber and the observation LED to clean it.
2. Wipe off any dirt on the two objective lenses with a cotton swab soaked in alcohol. Use new cotton swabs for cleaning the lens at each location and do not reuse them. At this time, wipe the optical fiber and the observation LED to clean it.
Alcohol
Use the alcohol with a purity of 99% or higher. Rust may occur.
Cleaning objective lens
Cleaning LED
3. Finally, wipe the objective lens dry with a cotton swab that does not soak alcohol to remove uneven wiping.
3. Finally, wipe the objective lens dry with a cotton swab that does not soak alcohol to remove uneven wiping.
4. After cleaning the objective lens, attach the fusing electrode rod to the fusion splicer.
Do not touch the electrode rod when installing.Also, be careful not to hit or bend the tip of the electrode rod.
5. Turn on the splicer power.
6. After closing the windshield, enter the maintenance menu from the main menu on the monitor screen and perform a screen stain inspection.The OK screen will be displayed during the inspection, and the objective lens cleaning will be completed.